Smoke Silver / Pearl Shad Laminate

Swimbait · 2 parts

Steps

1. 1

   Bring both fully cured colors to 330°F and load Smoke Silver and Pearl Shad into the paired barrels of a dual injector.

2. 2

   Seat both injector nozzles in the side-injection port and make one smooth, simultaneous shot; hold even pressure on both plungers.

3. 3

   Keep the injector orientation fixed until the cavities are packed, then let the baits cool before checking the back-to-belly split.

Both colors must have similar viscosity and be at the same shooting temperature for a clean laminate line. Heat each plastisol through full cure first, then cool both to 330°F. Purge the dual injector before seating it in the mold, and keep the Smoke Silver barrel aligned with the mold’s back side throughout the shot.

LureWrightPrecision materials for lure makers

Smoke Silver / Pearl Shad Laminate Swimbait · 2 parts Back4 oz · Medium blend Smoke Silver Load this color on the dark-side barrel of the dual injector for the Smoke Silver back. Medium base Shoot at 330°F Mold 673 Swimbait — 4.75" side-injection top/bottom laminate, 5 cavity Basstackle Make Smoke Silver · per 8 oz Crystal Inject 8 oz Crystal Color Smoke 12 drops Crystal Spark Holo Silver .008 1/4 tsp Belly4 oz · Medium blend Pearl Shad Load this color on the light-side barrel of the dual injector for the Pearl Shad belly. Medium base Shoot at 330°F Mold 673 Swimbait — 4.75" side-injection top/bottom laminate, 5 cavity Basstackle Make Pearl Shad · per 8 oz Crystal Inject 8 oz Crystal Color White 12 drops Crystal Shift Pearl 0.15 g Steps 1.Bring both fully cured colors to 330°F and load Smoke Silver and Pearl Shad into the paired barrels of a dual injector. 2.Seat both injector nozzles in the side-injection port and make one smooth, simultaneous shot; hold even pressure on both plungers. 3.Keep the injector orientation fixed until the cavities are packed, then let the baits cool before checking the back-to-belly split. Both colors must have similar viscosity and be at the same shooting temperature for a clean laminate line. Heat each plastisol through full cure first, then cool both to 330°F. Purge the dual injector before seating it in the mold, and keep the Smoke Silver barrel aligned with the mold’s back side throughout the shot.